Week 2: 2/22/2018

-
Today we did further research on the parts that we need for our Catapult and Trebuchet. These include the lengths and places we are going to purchase the parts from. The Solidworks rough draft was completed but needs to be dimensioned and redesigned to better fit our final creation. 


Comments

Post a Comment

Popular posts from this blog

Week 5: 3/14/2018

-
Today we redesigned the Catapult to guarantee that it will work the way we want it to. Our design will include large rubber bands that will create power to launch the object. We will pull the arm back into a stable position and lock it in and release when we are ready to fire the catapult. The Trebuchet is almost the same but will be using weights instead of a rubber band.
Read more

Week 5: 3/12/2018

-
Image
On Thursday 3/8/2018 we went to home depot to purchase the wood and it went well. This was a lot of wood because we are building a Trebuchet and a Catapult. We hope to begin building next week if we get approved by Mr Martin. Our design for the Catapult was not up to par because our source of energy was not going to work. The Trebuchet design was good but we have to change the Catapult. Our design for the Catapult will be using Torsion. A rope will be wrapped around the arm of the catapult to create Torque and will be released.
Read more

Week 3: 2/28/2018

-
Image
Today we created the full list of materials and prices that we needed. We added a few things that we forgot on the original list. We looked over solidworks to polish it out. This will probably be done by next week and the building of the catapult and Trebuchet will begin soon. The group has made a plan to go to home depot to buy the materials on Sunday.  Source: https://www.dailydot.com/wp-content/uploads/f94/e2/79c8d63466fa3e050eabce1845f6e02d.jpg Source: https://www.dailydot.com/wp-content/uploads/f94/e2/79c8d63466fa3e050eabce1845f6e02d.jpg
Read more